|
On the floor: Used the scrap piece f
the oval die cuts and adhered to floor.
Die cut the oak leaf (Die-Versions
"Old Oak Leaves - Whispers") from white cardstock. Direct
to paper with "Forest Moss" and "Rusty Hinge" on
the acorns. Electronically cut an under layer, applied glue all over
it, adhered the die cut and then sprinkled with various glitters.
Cut it apart and reassembled onto card floor.
|
Die cut the "Happy Birthday",
inked with "Carved Pumpkin and embossed with Emerald Creek
"Thanksgiving" embossing powder.
Cut a piece of white cardstock the
width of my ribbon. Adhered the ribbon (Sheer Butterflies Lavender),
trimming the left edge to contour with the oval and a picot on the
right edge. Adhered to floor. Adhered the Happy Birthday die cut.
Electronically cut the fairy from
white cardstock. I had a Prisma Color Premier marker "Light
Olive Green" on my desk so colored the fairy with it... and had
a Spectrum NoirCT4 marker for the wings. Applied Versamark on the
wings only and clear embossed, then heat the embossing and sprinkled
with a couple colors of glitter.
Cut a narrow piece of the rust
cardstock, scored down the middle and adhered to floor to act as my
stopper. adhered the fairy to it and the floor as well.
|
